Juniper-networks M20 Uživatelský manuál Strana 12

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 34
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 11
ATM OC12 PIC
JUNOS 3.1 and laterSoftware release
One OC12 port
Power requirement: 0.43 A @ 48 V (20.8 W)
Conforms to ANSI T1.105-1991 and T1E1.2/93-020R1
ATM and SONET/SDH standards compliant
Alarm and event counting and detection
Compatible with well-known ATM switches
ATM switch ID, which displays the switch IP address and local interface name of the
adjacent Fore ATM switches
Description
High-performance parsing of SONET/SDH frames
OAM fault management processes Alarm Indication Signal (AIS) and Remote Defect
Indicator (RDI) cells
ASIC-based packet segmentation and reassembly (SAR) management and output port
queuing
16-MB SDRAM memory for ATM SAR
Packet buffering, Layer 2 parsing
Hardware features
Multiprotocol Label Switching (MPLS) circuit cross-connect (CCC) for leveraging ATM
access networks
Support for user-configurable virtual circuits (VC) and virtual paths (VP)
ATM Inverse Address Resolution Protocol (ARP), which enables routers to automatically
learn the IP address of the router on the far end of an ATM permanent virtual circuit
(PVC)
Unspecified bit rate (UBR) traffic shaping
Fine-grained variable bit rate (VBR) traffic shaping
Outbound PIC queues cells on a per-VC basis
EncapsulationsAAL5 subnetwork attachment point (SNAP)
Software features
Duplex SC/PC connector (RX and TX)
Optical interface supportsee Table 3 on page 13
Cables and connectors
One tricolor per port:
OffNot enabled
GreenOnline with no alarms or failures
AmberOnline with alarms for remote failures
RedActive with a local alarm; router has detected a failure
LEDs
12 ATM OC12 PIC
M20 Internet Router PIC Guide: End-of-Life PICs
Zobrazit stránku 11
1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 33 34

Komentáře k této Příručce

Žádné komentáře