Juniper-networks JUNOS OS 10.4 Uživatelský manuál stáhnout pdf (Strana 151)

NOTE: The only difference in the two commands is the use of the

mep-statistics and delay-statistics keyword.

The fields for these commands are described in Table 4 on page 131.

Table 4: Show Ethernet Delay Command Parameters

DescriptionParameter RangeParameter

Specifies an existing maintenance domain (MD) to use.Existing MD namemaintenance-domain name

Specifies an existing maintenance association (MA) identifier

to use.

Existing MA identifiermaintenance-association ma-id

When a MEP has been specified, display statistics only for the

local MEP.

1–8191local-mep identifier

When a MEP has been specified, display statistics only for the

discovered MEP.

1–8191remote-mep identifier

The number of entries to display in the results table. By default,

all 100 entries are displayed if they exist.

1–100 (default:100)count count

NOTE: For each MEP, you will see frame counters for sent and received

Ethernet frame delay measurement frames whenever MEP statistics are

displayed.

Documentation

Ethernet OAM•

• Ethernet Frame Delay Measurements on page 125

• Configuring MEP Interfaces to Support ETH-DM on page 128

• Triggering an ETH-DM Session on page 129

• Configuring One-Way ETH-DM with Single-Tagged Interfaces on page 131

• Configuring Two-Way ETH-DM with Single-Tagged Interfaces on page 136

• Configuring ETH-DM with Untagged Interfaces on page 140

Example: Configuring One-Way Ethernet Frame Delay Measurements with

Single-Tagged Interfaces

This example uses two MX Series routers: MX-1 and MX-2. The configuration creates a

CFM down MEP session on a VLAN-tagged logical interface connecting the two (ge-5/2/9

on Router MX-1 and ge-0/2/5 on Router MX-2).

Chapter 11: ITU-T Y.1731 Ethernet Frame Delay Measurements

1 2 ... 146 147 148 149 150 151 152 153 154 155 156 ... 207 208

Žádné komentáře

Juniper-networks JUNOS OS 10.4 Uživatelský manuál Strana 151