Juniper-networks J4350 Uživatelský manuál stáhnout pdf (Strana 149)

Configuring Autoinstallation

4. To check the configuration, see “Verifying Autoinstallation” on page 12 9.

Table 42: Conf

iguring Autoinstallation

Task J-Web Configuration Editor CLI Configuration Editor

Navigate to the System level in the

configuration hierarchy.

1. In the J-Web interface, select

Configuration>View and Edit>

Edit Configuration.

2. Next to System, click Configure or

Edit.

From the [edit] hierarchy level, enter

edit system

Enable autoi

nstallation.

Select Autoi

nstallation,andthenclick

Configure.

Add the configuration servers by

specifying the URL address of a server

from which to obtain configuration files.

1. Next to Configuration servers, click

Add new entry.

2. Type the location of the

configuration server in the Url box.

3. If a password is required to access

theserver,typeitintothePassword

box.

4. Click OK to return to the

Autoinstallation page.

Enter set aut

oinstallation configuration

servers url .

Configure one o r more Ethernet or serial

interfaces to perform autoinstallation,

and one or two procurement protocols

for each interface. The router uses the

protocols to send a request for an IP

address from the interface.

BOOTP—Sends requests over

all interfaces.

RARP—Sends requests over

Ethernet interfaces.

SLARP—Sends requests over

serial interfaces.

1. Next to Interfaces, click Add new

entry.

2. Typethenameoftheinterfaceinto

the Interface name box.

3. Select one or two types of protocol

used by autoinstallation over the

interface. You can select Bootp,

Rarp, or Slarp.

4. Click OK to return to the

Autoinstallation page.

Enter set autoinstallation interfaces

interface-name ,thenoneofthe

following protocols:

bootp

rarp

slarp

Forexample,tosettwoaddress

procurement protocols, enter a

command like the following example:

set autoinstallation interfaces ge-2/0/0

bootp rarp

Verifying Autoinstallation

To verify that a Services Router is configured for autoinstallation,

perform the following task.

Verifying Autoinstallation Status

Purpose

Display the status of the autoinstallation feature on a Services Router.

Verifying Autoinstallation 129

1 2 ... 144 145 146 147 148 149 150 151 152 153 154 ... 283 284

Komentáře k této Příručce

Žádné komentáře

Juniper-networks J4350 Uživatelský manuál Strana 149

Komentáře k této Příručce

Související produkty a manuály pro Hardware Juniper-networks J4350